I have a problem with my skeg. How to replace and adjust a skeg on a Boreal Design Baffin kayak

A)  Replacing and installing a skeg is relatively easy following these 7 steps.  See attached file for steps and pictures:

1) Feed the spectra skeg line through while tubing from the skeg box towards the skeg dial and it appears.  Keep a few inches at the skeg box end loose.  

2) Prepare skeg box kit with two sides, the blade, pin and cord.   Feed the cord from one side through the lower hold of the skeg and attach to the other side and make a knot at each end. 

3) Attach the skeg assembly with the four bolts and washers.

4) Attach the skeg line to the 2nd hole on the blade and make a knot (bowline is best)

5) Hold the blade in the box in place with tape

6) Pull the excess line at the skeg dial end until tight.  Then assemble the skeg dial by feeding the line through bottom of dial.  Then insert dial into bolt hole. Attach nylon washer, stainless steel washer and nylon lockwasher and tighten. 

7) With dial set to 0.5 mark, make a knot around 2nd screw/bolt then tighten. 

B) Replacing the bungee cord at skeg end will need 4mm*length 12cm. and the length of the cord on both sides of the skeg kept 4cm long is fine.

​

• Related Articles

• I have a problem with my skeg. How do I fix and adjust my skeg line on my Riot or Boreal Design kayak?

  We walk you through the steps in this video on how to adjust and fix the skeg line and tension on your Riot or Boreal Design kayak. ​

• How to fix, adjust and centre a loose skeg on a Boreal Design Baffin kayak.

  In this short video we show you the steps to adjust and better centre a loose skeg on a Boreal Design Baffin sea kayak. 1) The two plastic plates on either side of the skeg have bolts that can be adjusted to better hold the skeg in position better. ...

• I have a problem with my skeg. How do I repair / replace a skeg on my Riot kayak?

  In this quick video we show you the steps to replace your skeg on your Riot Kayak.  Skeg replacement kits are available to purchase and ship to you here: https://boutiqueborealdesign.com/search?q=skeg+kit https://youtu.be/lmaqmN_Mhg0 1. Take out the ...

• I have a problem with my skeg, how do I fix my skeg? My skeg control lever only goes down to half way or is stuck

  We recommend the following as different options to fix: Rest or lift the stern (rear of kayak) above the ground or water, so the skeg can lower and raise freely. Try to pull firmly on the skeg to get it down all the way, till skeg reaches its full ...

• How to assemble and adjust your 2 piece paddle (Beluga, Riot or Boreal Design)

  In this short video we show you how to put together and adjust and set the correct length you want on your Beluga, Riot Kayaks or Boreal Design paddle.