In this quick video we show you the steps to replace your skeg on your Riot Kayak.  Skeg replacement kits are available to purchase and ship to you here: https://boutiqueborealdesign.com/search?q=skeg+kit

1. Take out the silcone and lossen the screws with spanner and srewdriver at the uphaul and downhaul slider control.

2. Open the slider cover

3. Cut the knot of rope and take out the rope

4. Assemble the spring into the skeg mount and put it into the skeg box.  

5. Put the new spectra line through the skeg blade

6. Make a knot so doesn't pull through the hole. 

7. Put the skeg blade into the skeg mount

8. Put the line into the hose feeding it back up to the slider box

9. Pass the line through the slider

10. Put the skeg blade down into the box

11. Fix the blade in place with tape

12.  Tighten the line

13.  Pass the line through the aluminum stop sleeve.  When the sleeve is 2.5 cm from the right edge of the slider, clamp the sleeve.

14.  Put the sleeve into the button

15.  Put the button into the slider box

16. Apply enough silicone on the slider cover

17. Then cover the slider. 

18.  Tighten the screws - tighten the rear screw / bolt first

19. Clean the excess silicone 

20. Use tie wrap to fix the white hose onto slider / footpedals

21. Apply silicone around the slider on inside then spread evenly

You are done!  

Hope this helps and gets you out on your way again.  See you on the water!