How do I fix a leak in my compartment or hatch?

How do I fix a leak in my compartment or hatch?

The first step to fixing a leak in your  compartment/hatch is identifying where the water is entering. The possibilities are:
  1. The hatch cover is not forming an adequate seal, perhaps due to improper maintenance (requires regular cleanings to remove salt water and other harsh particles); if after a proper cleaning the leak remains replacement hatch covers are available
  2. Broken or loose deck fittings may leave an opening in the hull where water can enter; replacement of these deck fittings should solve the problem
  3. Loose bulkheads, due to the flexing of the kayak over time, will allow water from the cockpit to enter your dry compartments. If the bulkhead is loose/ has popped out you will need to reseal it; please see Knowledge Base article on replacing a foam wall/bulkhead

  4. If the source of the leak is not readily apparent then you will need to do a ‘reverse leak test’ wherein you put water in the waterproof compartment and seal it tightly with the hatch cover. When you slowly roll the kayak you should be able to see where the water is coming out and fix accordingly.
  5. Replacement parts can be found through a dealer or directly through Kayak Distribution here
    IMPORTANT: Items that absolutely cannot get wet should always be stored in a dry bag for additional protection.

    • Related Articles

    • Basic kayak maintenance

      We’ve put a lot of time and thought into providing you with a quality craft and we stand behind our product 100%. By reading your kayak’s warranty agreement and following these few simple maintenance steps, you should have years of problem-free fun ...
    • How do I fix a leaking hatch (and replace the rim with a new seal)?

      1. If the leak in your rim is small then try the following first with some silicon: Tear off the removable glue/silicon of the hatch rim where it is leaking as best you can by hand.  Apply one full circle of glue to the hatch rim and screw parts, ...
    • How do I test my kayak for leaks for a warranty issue? These are the steps to do a water test.

      Here is a way to do a water test on your kayak to show where it leaks. All you have to do is fill the kayak up with some water through one of the hatches while it is on flat ground. Concrete usually works the best because you can see the water. Then ...
    • My Impulse Drive does not spin smoothly. How can I fix this?

      There are a few reasons why an Impulse Drive doesn't spin smoothly: It needs cleaning (see other maintenance tips at end of this video) The main spindle of the impulse drive is offset The drive cover is too tight The video below shows how to fix this ...
    • How to replace a hatch rim (for a rubber style hatch cover style)

      Replacing your hard plastic hatch rim on your kayak is relatively easy.  You will need a multi-head screwdriver, a sharp knife and some good quality silicon. Please see attached instructions on a step by step guide to removing old rim and replacing ...